|
WIRE NAIL MAKING MACHINES (N6-E)
Wide experience has enabled us to offer newly designed 'NE' series
machines. These machines are equipped with compact geared type feeding
system. Thousands of our 'N series machines are satisfactorily working
in our country as well as abroad. Like our earlier 'N' series machines,
these machines are capable of producing different types of nail heads
and points.
OPERATION:
The wire form wire
coil passes through straightening rolls and fed intermittently into the
gripping dies which close firmly head of the nail. The grip is loosened
now and the required length of wire is fed forward. Then the cutting
tools cut the point a little forward of the grip leaving sufficient
wire projecting to form the head of the next nail. This sequence of
operations is repeated at each revolutions of the machines and the
nails are produced constantly.
CONSTRUCTION:
The frame of the
machine is extremely rigid, all moving parts are of ample dimensions
and precisely made from quality material under strict quality control,
which ensures the smooth running of machine in spite of high rate of
output.
DRIVE:
Keeping in view
to-day's technology, our machines are equipped with well proven 3 shaft
system. The main shaft controls Heading, while two side shafts control
Grapping, Cutting operations and nail length operation, through gears,
which ensures the accident-free motions.
WIRE FEED:
The wire feed is
actuated by means of gears mounted on one side shaft which moves the
feed slide through connecting-rod. The setting of the desired length
obtained quickly and easily.
BEARINGS:
The bush bearings
are made from special metals and are of ample dimensions. While
manufacturing, care has been taken and provided with continuous
approach of oil which ensures the smooth running and long life.
Heavy load transmitting bearings are of needle roller type which ensures the smooth running and long lasting.
TOOLS:
The setting of the
machine is made very easy and less time consuming; even unskilled
operators are able to handle the machines without difficulty after a
short time observation. Their special feature is round type Grapping
dies which gives 8/10 times the service of common flat dies normally
used in similar machines.
CRANK SHAFTS:
The main crank is
counter-balanced and runs in 4 bearings in oil bath chamber. Even
smooth running and equal distribution of loads ensure long life.
LUBRICATION:
The bevel gears and
the crank shafts are totally enclosed in oil chamber and require no
attention, except periodical checks. All other lubrication points are
served by a centralised pressure lubrication system.
TECHNICAL SPECIFICATION
Wire Diameter S.W.G. (mm)
|
: 10 - 4 (3.25 - 5.89) |
|
Nail Length mm (inch)
|
: 100 - 150 (4" - 6")
|
|
Max. Nails/min.
|
:
200 |
|
Power Required hp/kW
|
:
10
/
7.5
|
|
Appox. Nett Weight kgs. |
:
2845 |
|
Appox. Gross Weight kgs. |
:
3000 |
|
